Introduction | A antirust paint comprising chlorinated rubber, iron oxide antirust pigments, plasticizer, additives and solvents,etc. |
Applications | Applicable to the ship bottom antirust and ship waterline, sea steel structurebuildings and other steel strucures for corrosion protecton.Also can be used as intercoat in ship bottom antifoulingpaint. |
Properties | Poor permeability of gas to the paint film, excellent water resistance,good corrosion resistance and decoration performance. Fast drying, dry faster than oily paint several times, excellent low temperature construction performance down to -20 ℃ ~50 ℃ . Excellent alkali resistance and durability. good adhesion to steel. Good performance of recoating on the old paint film, convenient repairment. |
Film thickness and spreading rate |
DFT:75μm Theoretical spreading rate:236g/ m /75μm WFT: 179μm |
Physical performance |
Appearance:iron red Volume solid:42±3% Flash point: 31℃ Viscosity: |
Surface pretreatment |
Sandblasting to Sa2.5 as described in ISO standard, and surface roughness between 40-70μm; or St2 for surface treatment is required if using power tool. |
Application parameters |
Proportion: one component Coating method |
Airless spraying: recommended conditions: inlet pressure: 4~5kgf/ cm , compression ratio: 1:65, Type of nozzle: flow / spraying width ––19/30 26/35 Brushing : A precoating or small area of painting is recommended, but the dry film thickness must meet the specified requirements. Roller coating: Can be used in a small area of painting,but the dry film thickness must meet the specified requirements. Thinner: thinner JL101 Pot life : No limit Recommended coating layer(s): 2 layers, with its DFT 150μm Drying process |
|||||
Substrate temperature |
Touch dry | Hard dry | recoating interval | ||
shortest | longest | ||||
5℃ | 4h | 24h | 12h | No limit | |
20℃ | 2h | 12h | 8h | No limit | |
30℃ | 1h | 8h | 6h | No limit | |
Application conditions |
The substrate temperature≥ 5℃ and at least 3℃ higher than the dew point of the air temperature; The temperature and relative humidity shall be measured nearby the substrate to be coated; relative humidity ≤ 85%;Good ventilation is required useful for film drying process. |
||||
Typical coating compatibility |
Preceding coats: JL615,JL846,JL546,etc. Subsequent coats: various colour chlorinated rubber topcoat, JL839,JL837 antifouling paint. |
||||
Storage | The product must be stored under standard conditions as described by related state regulations, wherein the environment must be dry, cool, well ventilated and away from heat and/or fire. The packaging containers must be kept sealed. |
||||
Load and unload |
Cautious operation; Stir well before use. |
Packaging specifications |
20L/26kg |
Health and safety |
Please note the warning logo labeled on packaging container and operate in a circumstance with good ventilation, avoid swallowing or inhaling paint mist, avoid skin contact or use suitable detergent, soap and water to clean immediately if the paint splashed on the skin, and use flowing clean water to rinse eyes if splashed, or carry on medical care immediately. For more details about health and safety as well as the cautions of the product, please refer to our "product safety manual" MSDS. |
Claim | The information given on this product manual is derived from experiments and practical applications. We only guarantee the quality,of the said product since conditions of use are beyond the manufactures control. We reserve the rights to revise the specifications of the product without prior notice. |