Introduction | A antirust paint comprising chlorinated rubber, plasticizer, aluminum powder antirust pigments, additives and solvents,etc. |
Applications | Applicable to the ship bottom and waterline, hull, superstructure, sea and land steel structure building for corrosion protection. |
Properties | Poor permeability of water vapor and oxygen to the paint film, excellent water resistance, good corrosion resistance and decoration performance. Fast drying, dry faster than oily paint several times, excellent low temperature construction performance down to -20℃~50℃ . good adhesion to steel, excellent alkali resistance and durability.Excellent mutual solubility and good adhesion between the film layers, recoating on the old paint film, without removal of the solid old film, convenient repairment. Unsaponifiable in seawater,good compatibility with cathodic protection. |
Film thickness and spreading rate |
DFT:60μm Theoretical spreading rate:193g/ m /60μm WFT: 143μm |
Physical performance |
Appearance:Silver gray Volume solid:42±3% Flash point: 31℃ Viscosity: |
Surface pretreatment |
Sandblasting to Sa2.5 as described in ISO standard, and surface roughness between 40to70μm; or St2 for surface treatment is required if using power tool. |
Application parameters |
Proportion: one component Coating method Airless spraying: recommended conditions: inlet pressure: 3~4kgf/ cm , compression ratio: 1:65, Type of nozzle: flow / spraying width ––19/30 26/35 Brushing : A precoating or small area of painting is recommended, but the dry film thickness must meet the specified requirements. Roller coating: suitable for use, but the dry film thickness must meet the specified requirements. Thinner: thinner JL101 Pot life : No limit |
Recommended coating layer(s): 2 layers, with its DFT 120μm Drying process |
|||||
Substrate temperature |
Touch dry | Hard dry | recoating interval | ||
shortest | longest | ||||
5℃ | ≤4h | 24h | 12h | No limit | |
20℃ | ≤2h | 12h | 8h | No limit | |
30℃ | ≤1h | 8h | 6h | No limit | |
Application conditions |
The substrate temperature≥ 5℃ and at least 3℃ higher than the dew point of the air temperature; The temperature and relative humidity shall be measured nearby the substrate to be coated;relative humidity ≤ 85%;Good ventilation is required useful for film drying process. |
||||
Typical coating compatibility |
Preceding coats: epoxy shop primer, inorganic zinc silicate shop primer Subsequent coats: JL616 high build chlorinated rubber iron oxideantirust paint, or chlorinated rubber topcoat |
||||
Storage | The product must be stored under standard conditions as described by related state regulations, wherein the environmentmust be dry, cool,well ventilated and away from heat and/or fire. The packaging containers must be kept sealed. |
||||
Load and unload |
Cautious operation; Stir well before use. | ||||
Packaging specifications |
20L/24kg | ||||
Health and safety |
Please note the warning logo labeled on packaging container and operate in a circumstance with good ventilation, avoid swallowing or inhaling paint mist, avoid skin contact or use suitable detergent, soap and water to clean immediately if the paint splashed on the skin, and use flowing clean water to rinse eyes if splashed, or carry on medical care immediately. For more details about health and safety as well as the cautions of the product, please refer to our "product safety manual"MSDS. |
||||
Claim | The information given on this product manual is derived from experiments and practical applications. We only guarantee the quality,of the said product since conditions of use are beyond the manufacture control. We reserve the rights to revise the specifications of the product without prior notice. |