Here is
             Kailin Advanced Material Co.,Ltd.
       Professional  efficient modern environmental
ou want to say or what you want to express.
Epoxy non-toxic anti-corrosion coating
Product Detail
Share to:

H06-WD non-toxic anti-corrosion coating

1. Composition: H06-WD non-toxic anti-corrosion paint for drinking water tank is made of non-toxic grade epoxy resin, titanium dioxide and vegetable oil after esterification and polymerization. It is formulated with organic solvents, additives and curing agents. A: B = 4:1).
2, performance: with film toughness, wear resistance, collision resistance and other characteristics. The paint film is resistant to seawater, fresh water and diesel oil, and it is also resistant to splashes of gasoline, fuel, lubricants and such substances. However, it is not resistant to inorganic acids, alkalis and strong oxides. Limited tolerance to strong solvents (eg ketones, esters) and vegetable oils.
3, use
(1) Used as a topcoat or intermediate paint for epoxy paints in severely corrosive environments.
(2) This product is harmless to cereals and is used as an anti-corrosion surface coating for foods such as drinking bins and grain bins.
Physical parameters 
Flash point: 26℃
Dry: 2 hours (20°C)
Finger touch: 6-8 hours (20°C)
Fully cured: 7 days
Attached to: ≤1 level
Flexibility: ≤1 mm
Anti-impact: ≥50 kg·cm
Wear resistance:   Weight loss ≤ 0.100 g (500g, 500 rpm)
 Salt spray resistance: No blistering, no cracking, no rust (100μm, 600 hours)
Water resistance:    Supporting thickness for 30 days without change (100μm, 7 days, 25±1°C distilled water)
Impact on drinking water: Meet the requirements of GB5369, GB5749 and GB17219-98
Construction instructions
The mixing ratio: Base: Curing agent = 4:1.
Construction method: Airless spray Brush (Flush)
Diluent: Jinling brand special thinner
Maximum usage: 10%  
Spray hole: 0.018—0.021"
Spray pressure: 250 Kg/㎡ (Airless spray data is for reference only, it can be adjusted in practice)
Tool cleaning: Jinling brand tool cleaning agent  
Film thickness: Wet film: 175 microns。 Dry film: 100 microns. (See "Remarks")
Surface treatment: New steel: sandblasted to Sa2.5 standard. If necessary, a suitable shop primer may be applied to protect the freshly blasted surface. The shop primer and the contaminated parts that were damaged during storage and processing should be thoroughly cleaned, and then the damaged parts should be repaired with this product.
Maintenance: Remove grease with a suitable cleaner. Use high pressure fresh water to remove salt and other contaminants, and use sand blasting or power tools to remove floating rust and other loose material. Flatten the corners, remove the residue, and make up the complete paint film to the original film thickness.
Construction conditions: The construction surface should be clean and dry. The surface temperature should be higher than the dew point to avoid condensation. It should be noted that temperatures below the freezing point or freezing point can freeze the surface and affect the adhesion of the paint film. The temperature of the paint itself should be higher than 5°C to ensure normal construction performance. During construction and drying in a narrow space, ventilation should be extensive.
Note
Film thickness: The film thickness can be modified according to the purpose and location of use. Normal film thickness ranges from 50 to 125 μm, but this will change the coating rate and affect the drying time and recoating interval accordingly.